Furuno MU-152 Operator's Manual page 10

1. MOUNTING, WIRING
Required tools
The following tools should be prepared in advance for this installation.
• Electrical drill, Hole saw: φ18 mm, for making the mounting holes
• Jig saw, File: For making the mounting holes
• Phillips-head screw driver: #2, for securing the flush mount fixtures
• Cable tie: For securing the cables
How to remove/attach the hard cover
Before you install this monitor unit, remove the hard cover as follows.
The upper edge of the hard cover
Pull the upper
edge forward
while pressing
here with your
thumbs.
To attach the hard cover, follow the illustration in the figure below.
Tab
Hard cover
Cable connection
Before you install the monitor unit, run and connect all cables you use. See the interconnection
diagram at the back of this manual.
How to remove the hard cover
Cutout Cutout
Set the tabs on the top
of the hard cover to the
cutouts of the monitor
unit.
How to attach the hard cover
2
CAUTION
When lifting the monitor unit, hold
it together with the hard cover.
Grasping by the hard cover alone
may allow the monitor unit to fall,
resulting in possible bodily injury or
damage to the equipment.
Push the tabs on the
bottom of the hard cover
strongly (2 places).