How To Change The Signal Name - Furuno MU-152 Operator's Manual

2. ADJUSTMENTS
2.3.2

How to change the signal name

You can change the signal name ([RGB], [DVI1/2] or [VIDEO1/2/3]) to a name which is easier to
understand, such as the name of the connected equipment. The changed name is shown in the
DISP selection window, PIP selection window and the indication shown at the upper right of the
screen. See sections 3.4 and 3.5.
1. Press the MENU key to show the menu.
2. Press the or
3. Press the key to select the signal whose name you want to change. In the example below,
[RGB] is selected.
4. Press the key to select the character to change. In the example below, [G] of RGB is se-
lected.
5. Press the or
[5] is selected. You can set up to ten characters. "A to Z", "0 to 9", "–", ".", " " (space) are avail-
able.
6. To change another signal name, press the
nal name area. Repeat steps 3 to 5.
7. Press the MENU key to close the menu.
key to select [OSD].
RGB DVI1 DVI2 VIDEO1 VIDEO2 VIDEO3
H_POSITION
V_POSITION
TRANSLUCENT
PIP SW TIME
PIP SKIP
CUSTOM NAME
RGB
DVI1
DVI2
Signal
VIDEO1
name area VIDEO2
VIDEO3
CUSTOM NAME
RGB
DVI1
DVI2
VIDEO1
VIDEO2
VIDEO3
key to select an appropriate alphanumeric character. In the example below,
CUSTOM NAME
RGB
DVI1
DVI2
VIDEO1
VIDEO2
VIDEO3
OSD SYSTEM
11 (1~22)
19 (1~20)
OFF (OFF/ON)
OFF (OFF, 5~20)
OFF (OFF, V1/V2/V3)
= RGB
= DVI1
= DVI2
= VIDEO1
= VIDEO2
= VIDEO3
= RGB
= DVI1
= DVI2
= VIDEO1
= VIDEO2
= VIDEO3
= R5B
= DVI1
= DVI2
= VIDEO1
= VIDEO2
= VIDEO3
key several times to return the cursor to the sig-
16