Configuring Optional Lisp Map-Server Functionality - Cisco Nexus 7000 Series Configuration Manual

Configuring Optional LISP Map-Server Functionality

What to do next
Complete the optional LISP Map-Server configuration items as needed.
Related Topics
Configuring Optional LISP Map-Server Functionality
You can configure optional LISP Map-Server functionality.
Procedure
Step 1
Step 2
Step 3
Step 4
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
14
Command or Action
switch# show ip lisp
Example:
switch# show ipv6 lisp
Configuring LISP-ALT Functionality, on page 11
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
lisp site site-name
Example:
switch(config)# lisp site Customer1
switch(config-lisp-site)#
(Optional) allowed-locators rloc1 [rloc2
[...]]
Example:
switch(config-lisp-site)#
allowed-locators 172.16.8.1
2001:db8:aa::1
end
Example:
switch(config-lisp-site)# end
switch#
Configuring Locator ID Separation Protocol
Purpose
Purpose
Enters global configuration mode.
Enters LISP site configuration mode for the
indicated site. If the site does not exist, it will
be created.
Enters the locators that are to be allowed to be
included in the Map-Register message for the
LISP site being configured.
When the allowed-locators
Note
command is configured, all locators
listed on the Map-Server within the
LISP site configuration must also
appear in the Map-Register message
sent by the ETR for the
Map-Register message to be
accepted.
Exits LISP site configuration mode.