Cisco Nexus 7000 Series Configuration Manual page 56

Configuring Simple LISP Shared Model Virtualization
Step 8
Step 9
Step 10
Step 11
Step 12
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
44
Command or Action
ip lisp etr map-server map-server-address
key key-type authentication-key
Example:
switch(config-vrf)# ip lisp etr
map-server 10.0.2.2 key 0 Left-key
ipv6 lisp itr
Example:
switch(config-vrf)# ipv6 lisp itr
ipv6 lisp etr
Example:
switch(config-vrf)# ipv6 lisp etr
ipv6 lisp itr map-resolver
map-resolver-address
Example:
switch(config-vrf)# ipv6 lisp itr
map-resolver 10.0.2.2
ipv6 lisp etr map-server map-server-address
key key-type authentication-key
LISP Instance-ID Support
Purpose
You can configure up to two map
Note
resolvers if multiple map resolvers
are available.
Configures a locator address for the LISP map
server and an authentication key for which this
switch, acting as an IPv4 LISP ETR, will use
to register with the LISP mapping system.
You must configure the map serve with EID
prefixes and instance IDs matching those
configured on this ETR and with an identical
authentication key.
Note The locator address of the map
server may be an IPv4 or IPv6
address. In this example, because
each xTR has only IPv4 RLOC
connectivity, the map-server is
reachable using its IPv4 locator
addresses.
Enables LISP ITR functionality for the IPv6
address family.
Enables LISP ETR functionality for the IPv6
address family.
Configures a locator address for the LISP map
resolver to which this switch will send map
request messages for IPv6 EID-to-RLOC
mapping resolutions.
The locator address of the map resolver may
be an IPv4 or IPv6 address. In this example,
because each xTR has only IPv4 RLOC
connectivity, the map resolver is reachable
using its IPv4 locator addresses.
Note You can configure up to two map
resolvers if multiple map resolvers
are available.
Configures a locator address for the LISP
map-server and an authentication key that this