Cisco Nexus 7000 Series Configuration Manual page 38

Configuring the Map Server
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
26
Command or Action
switch# configure terminal
switch(config)# ip lisp itr map-resolver
map-resolver-address
switch(config)# ip lisp etr map-server
map-server-address {[key key-type
authentication-key ] | proxy-reply }
switch(config)# lisp site site-name
switch(config-lisp-site)# eid-prefix
[instance-id iid ] { EID-prefix [route-tag tag
]} [accept-more-specifics ]
switch(config-lisp-site)# authentication-key
key-type password
Repeat the preceding three steps to configure
each additional LISP site.
switch(config-lisp-site)# end
Configuring LISP ESM Multihop Mobility
Purpose
Enters global configuration mode.
Configures a Cisco NX-OS device to act as an
IPv4 Locator/ID Separation Protocol (LISP)
Map-Resolver (MR).
Configures the IPv4 or IPv6 locator address of
the Locator/ID Separation Protocol (LISP)
Map-Server to be used by the egress tunnel
router (ETR) when registering for IPv4 EIDs.
Configures a Locator/ID Separation Protocol
(LISP) site and enter site configuration mode
on a LISP Map-Server.
Configures a list of endpoint identifier
(EID)-prefixes that are allowed in a
Map-Register message sent by an egress tunnel
router (ETR) when registering to the Map
Server.
Configures the password used to create the
SHA-1 HMAC hash for authenticating the
Map-Register message sent by an egress tunnel
router (ETR) when registering to the
Map-Server.
—
Returns to privileged EXEC mode.