Cisco Nexus 7000 Series Configuration Manual page 57

LISP Instance-ID Support
Step 13
Step 14
Step 15
Step 16
Step 17
Step 18
Command or Action
Example:
switch(config-vrf)# ipv6 lisp etr
map-server 10.0.2.2 key 0 Left-key
ip lisp locator-vrf default
Example:
switch(config-vrf)# ip lisp locator-vrf
BLUE
ipv6 lisp locator-vrf default
Example:
switch(config-vrf)# ipv6 lisp
locator-vrf default
exit
Example:
switch(config-vrf)# exit
ip lisp itr
Example:
switch(config)# ip lisp itr
ip lisp etr
Example:
switch(config)# ip lisp etr
ipv6 lisp itr
Example:
switch(config)# ipv6 lisp itr
Configuring Simple LISP Shared Model Virtualization
Purpose
switch, acting as an IPv6 LISP ETR, will use
to register to the LISP mapping system.
The map server must be configured with EID
prefixes and instance IDs matching those
configured on this ETR and with an identical
authentication key.
Note The locator address of the
map-server may be an IPv4 or IPv6
address. In this example, because
each xTR has only IPv4 RLOC
connectivity, the map-server is
reachable using its IPv4 locator
addresses.
Configures a nondefault VRF table to be
referenced by any IPv4 locators addresses.
Configures a nondefault VRF table to be
referenced by any IPv6 locator addresses.
Exits VRF configuration mode and returns to
global configuration mode.
Enables LISP ITR functionality for the IPv4
address family.
Enables LISP ETR functionality for the IPv4
address family.
Enables LISP ITR functionality for the IPv6
address family.
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
45