Configuring the Client to Download Files from DHCP Server
Step 15
Step 16
Step 17
Step 18
Configuring the Client to Download Files from DHCP Server
Note
Procedure
Step 1
Step 2
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
64
Command or Action
no switchport
Example:
Device(config-if)# no switchport
ip address address mask
Example:
Device(config-if)# ip address 10.10.10.1
255.255.255.0
end
Example:
Device(config-if)# end
copy running-config startup-config
Example:
Device(config-if)# end
You should only configure and enable the Layer 3 interface. Do not assign an IP address or DHCP-based
autoconfiguration with a saved configuration.
Command or Action
configure terminal
Example:
Device# configure terminal
boot host dhcp
Example:
Device(conf)# boot host dhcp
Performing Device Setup Configuration
Purpose
Puts the interface into Layer 3 mode.
Specifies the IP address and mask for the
interface.
Returns to privileged EXEC mode.
(Optional) Saves your entries in the
configuration file.
Purpose
Enters global configuration mode.
Enables autoconfiguration with a saved
configuration.