Cisco Nexus 7000 Series Configuration Manual page 67

LISP Instance-ID Support
Step 14
Step 15
Step 16
Step 17
Step 18
Command or Action
Repeat Step 13 to configure another locator
address for the LISP map resolver
Example:
switch(config-vrf)# ip lisp itr
map-resolver 172.16.1.6
ip lisp itr
Example:
switch(config-vrf)# ip lisp itr
ip lisp etr
Example:
switch(config-vrf)# ip lisp etr
ip lisp locator-vrf default
Example:
switch(config-vrf)# ip lisp locator-vrf
BLUE
ipv6 lisp locator-vrf default
Example:
Configuring Large-Scale LISP Shared Model Virtualization
Purpose
You can configure up to two map
Note
resolvers if multiple map resolvers
are available.
Configures a locator address for the LISP map
resolver to which this switch will send map
request messages for IPv4 EID-to-RLOC
mapping resolutions.
Note In this example, a redundant map
resolver is configured. (Because the
MR is co-located with the xTRs in
this case, this command indicates
that this xTR is pointing to itself for
mapping resolution (and its
neighbor xTR/MS/MR at the same
site).
The locator address of the map
Note
resolver may be an IPv4 or IPv6
address. In this example, because
each xTR has only IPv4 RLOC
connectivity, the map resolver is
reachable using its IPv4 locator
address.
Note You can configure up to two map
resolvers if multiple map resolvers
are available.
Enables LISP ITR functionality for the IPv4
address family.
Enables LISP ETR functionality for the IPv4
address family.
Configures a nondefault VRF table to be
referenced by any IPv4 locators addresses.
Configures a nondefault VRF table to be
referenced by any IPv6 locator addresses.
Cisco Nexus 7000 Series NX-OS LISP Configuration Guide
55