Table of Contents
Advertisement
Feed the cables from the suspension arm down through the tertiary arm spigot.
You may also need to feed the cables coming up the tertiary arm, down through the bottom of the spigot as well.
Re-insert the locking plate to secure the arm, then proceed with connecting the wires ensuring you match the colours /
polarities.
Tertiary arm
mounting spigot
Sliding Cover
securing screw
Once the cables are connected, feed the cables into the arm joint and place a white cap onto the bottom of the joint.
Repeat for each arm.
For the Primary lighthead the camera will need to be attached.
Warning, Please observe the Cable Polarities and ensure that they
match, incorrectly wiring the device will cause damage to the system
Secure the arm
by replacing the
locking clip in
the back of the
arm, slide the
cover down and
re-fix
Connect the wires
as shown
(Please note, the
coaxial cable
connections may
differ slightly)
Page 22 of 39
Advertisement
Table of Contents
Troubleshooting
