Satel INT-TSG Quick Installation Manual

INT-TSG
KEYPAD
The alarm system should be installed by qualified personnel.
Disconnect power before making any electrical connections.
The INT-TSG keypad is designed for indoor installation. The place of installation should be
readily accessible to the system users.
1. Open the keypad enclosure (Fig. 1). The enclosure opening tool, shown in the illustration,
is included in the keypad delivery set.
2. Place the enclosure base on the wall and mark the location of mounting holes. Be sure to
take into account the tamper element mounting hole.
3. Drill the holes for wall plugs (screw anchors).
4. Pass the cables through the opening in the enclosure base.
5. Using wall plugs (screw anchors) and screws, fasten the enclosure base to the wall.
6. Connect the DTM, CKM and COM keypad terminals to the appropriate terminals of the
control panel communication bus (Fig. 2). It is recommended that the unshielded non-
twisted cable be used for making the connection. If you use the twisted-pair type of cable,
remember that CKM (clock) and DTM (data) signals must not be sent through one
twisted-pair cable. The wires must be run in one cable. The length of cables must not
exceed 300 m.
®
Quick installation guide
Full installation manual is available on www.satel.eu
int-tsg_sii_en 06/15