To Mount The Rear Casing To The Wall; To Mount The Pcb To The Rear Casing; Connecting The Electrical Wiring - Daikin BRP069A61 Installation Manual

5 Installation
a a
b b
a Mounting holes
b Bottom knockout holes
c Rear knockout holes
INFORMATION
Wiring from the bottom. ALWAYS replace any removed
knockout holes with the grommets delivered in the
accessory bag. Before inserting the grommets into the
holes, cut them open with a utility knife, so that you can let
the wiring enter the adapter through the grommets. The
grommets MUST be inserted into the holes before you
insert the wiring into the adapter.
NOTICE
Wiring from the rear. When removing knockout holes,
make sure to remove any sharp edges that might arise
around the holes, this to protect the wiring from damage.
5.1.1

To mount the rear casing to the wall

1 Hold the rear casing against the wall and mark the position of
the holes.
2 Drill the holes.
1 2
3 Mount the rear casing to the wall with the screws and plugs
from the accessory bag.
Installation manual
6
a
c
c
b
3×
3
5.1.2

To mount the PCB to the rear casing

NOTICE: Risk of electrostatic discharge
Before mounting the PCB, touch an earthed part (a
radiator, the casing of the indoor unit, ...) to eliminate static
electricity and protect the PCB from damage. ONLY handle
the PCB by its sides.
5.2

Connecting the electrical wiring

DANGER: RISK OF ELECTROCUTION
Do NOT turn on the power supply (both the power supplied
by the indoor unit to X3A and the detection voltage
supplied to X1A) before you have connected all the wiring
and closed the adapter.
NOTICE
To prevent damage to the PCB, it is NOT allowed to
connect the electrical wiring with the connectors already
connected to the PCB. First connect the wiring to the
connectors, then connect the connectors to the PCB.
WARNING
To prevent damage and/or injury, do NOT make any
connections to X1A and X2A on LAN adapter BRP069A62.
3×
4×
BRP069A61+BRP069A62
Daikin Altherma LAN adapter
4P463935-1E – 2018.10