Hydromassage Jets; Swim Jets; Waterfall Valve; Air Controls - Endless Pools X2000 SwimCross Owner's Manual

HYDROMASSAGE JETS

LARGE HYDROMASSAGE Jets - This jet provides a unique, pulsating
massage. The water flow is adjustable in that it can be turned from low
to high (by rotating the jet faceplate ¼ turn).
MIDSIZE DIRECTIONAL JET - These jets allow you to redirect the
jet stream by changing the position of the nozzle. The water flow is
adjustable in that it can be turned from low to high (by rotating the jet
faceplate ¼ turn)
MIDSIZE ROTATIONAL JET - These jets provide a rotating massage
pattern. The water flow is adjustable in that it can be turned from low to
high (by rotating the jet faceplate ¼ turn)
Mini JET - These jets deliver a direct, more focused massage. The
water flow is adjustable in that it can be turned from low to high (by
rotating the jet faceplate ¼ turn)

SWIM JETS

Swim Jet - The Swim Jet provides a powerful stream of water used to
simulate a water current.
Getting Started

WATERFALL VALVE

Your exercise system is equipped
with three waterfalls, two in the swim
side and one in the spa side. The left
illustrated valve is used in the swim
side. The flow is regulated by turning
the waterfall valves in either direction.
Jet pump 1 must be on for waterfall to run on spa side.

AIR CONTROLS

Your exercise system is equipped with two air valves. The
air valves will add or remove air to the hydromassage jet
system. Rotate valve to see which hydromassage jets are
affected.

QUICK START-UP INSTRUCTIONS

BEFORE YOU FILL YOUR EXERCISE
SYSTEM
Make sure your exercise system has been properly installed per all local
codes, including the location of the exercise system, the foundation of
the exercise system, as well as the electrical installation of the exercise
system.
DO:
• Know which water treatment system you will be using and make sure
you have necessary chemicals available. Read all of the instructions
that come with the system.
• Have 5-way Test Strips Available.
• Have pH/Alkalinity Up & Down available.
• Know the Hardness of your water, contact your dealer to help you
with this information. See Water Quality and Maintenance for more
information.
• Purchase the Clean Screen
™
contaminants from the tap water. This is recommended, not required.
DON'T:
• Fill the exercise system with hot water or cold water with cold water
temperature below 10º C (50º F)! Tripping of the high-limit thermostat
may result causing your exercise system to stop functioning.
• Fill the exercise System with "softened" water that is outside
WATKINS WELLNESS recommended range, as this may damage
the Exercise System's equipment. See Water Quality and Maintenance
for more information.
Page 11
pre-filter to remove unwanted