D-Link AC1200 User Manual page 59

Section 4 - Configuration
Enable MPPC: Toggle this switch to enable Microsoft Point-to-Point Compression
(MPPC). This setting is disabled by default.
Miscellaneous
NAT: Toggle this switch to enable Network Address Translation (NAT). This
setting is enabled by default.
Firewall: Toggle this switch to enable firewall functionality. This setting is
enabled by default.
RIP: Toggle this switch to enable Routing Information Protocol (RIP). This
setting is disabled by default.
Ping: Toggle this switch to enable WAN Ping. This setting is disabled by
default.
Isolate Toggle this switch to enable connection isolation. This setting is
connection:
disabled by default.
Click Apply when you are done.
D-Link DIR-1210 User Manual
PPTP (cont)
55