D-Link AC1200 User Manual page 33

Section 4 - Configuration
NAT: Toggle this switch to enable Network Address Translation (NAT). This
setting is enabled by default.
Firewall: Toggle this switch to enable firewall functionality. This setting is
enabled by default.
RIP: Toggle this switch to enable Routing Information Protocol (RIP). This
setting is disabled by default.
Ping: Toggle this switch to enable WAN Ping. This setting is disabled by
default.
Isolate Toggle this switch to enable connection isolation. This setting is
connection:
disabled by default.
Ethernet
MAC address: The default MAC address is set to the Internet port's physical interface
MAC address on the router. You can edit that address manually here.
Clone MAC
Toggle this switch to clone the MAC address of the device you are
address of your
using to access the web UI. Note that no two MAC address within the
NIC:
same subnet can be the same.
Restore Default
Click here to restore your router's default MAC address.
MAC Address:
D-Link DIR-1210 User Manual
Static IPv4 (cont)
29