Pressure Switch; Sump Cover - Maytag MAH21PD Supplemental Service Instructions

PRESSURE SWITCH

The pressure switch was relocated from the
console and mounted to a bracket extension
molded as part of the pump assembly. A
vertical outlet on the pump has a rubber cap
positioned over the outlet with a spout and
is clamped into position. The nipple of the
pressure switch is inserted into the rubber
spout. Pressurization in the vertical outlet
of the pump actuates the pressure switch
and determines proper fill levels.
Removal
1. Remove the rear access panel or the
front panel to access the pressure
switch.
2. Place a towel beneath the pump.
3. Remove the plastic bag covering the
pressure switch. Press in the locking
tabs on the back of the pressure switch
and pivot the pressure switch off the
pump bracket. Figure 7
4. Grasp the pressure switch and lift the
nipple of the pressure switch from the
pump cap.
Figure 6
Press In
Tabs
Figure 7
16008203-03

SUMP COVER

The sump cover is located in the lower rear
area of the outer tub assembly, directly
above the sump area and the drain outlet.
The purpose of the sump cover is to cap
ture the detergent dispensed into the top
dispenser. By capturing the detergent, the
washer can provide a better mix of water
and detergent in the wash water. During
normal operation, the sump cover is flushed
of detergent during the wash cycle.
Removal
1. Remove the front panel, tub cover and
the spinner.
2. Remove the mounting screw securing
the cover to the outer tub.
Figure 8
3. Lift the front of the sump cover and
disengage from rear lip of outer tub.
Figure 9
©2002 Maytag Appliances
5