Temperature And Speed Switch; Pressure Switch - Maytag NAV2330 Service Manual

Disassembly Procedures
!
WARNING

Temperature and Speed Switch

1. Loosen control hood assembly, see "Control Hood
Assembly" procedure steps 1 and 2.
2. Slide a soft cloth under the knob, wrapping the entire
knob and pull gently away from the control panel.
3. Disconnect wires from switch terminals.
4. From the front, press inward on black plastic tabs
next to the switch shaft and rotate switch to release
switch from control hood mounting plate.
5. Reverse procedure to reassemble.
NOTE: See appropriate wiring diagram when rewiring
components.

Pressure Switch

End panel
(left side)
Screw
Control
knob
Rocker
switch
Timer
knob
Graphic
panel
20
Top
cover
Screw
Timer
knob
skirt
Screw
Hold-down
Typical Control Panel Assembly
16022937 Rev. 0
To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
1. Loosen control hood assembly, see "Control Hood
Assembly" procedure steps 1 and 2.
2. Disconnect wires and plastic hose from pressure
switch.
3. Remove screws securing pressure switch to control
hood mounting plate.
4. Reverse procedure to reassemble.
NOTE: See appropriate wiring diagram when rewiring
components.
NOTE: Before connecting hose to pressure switch, blow
air through pressure hose to remove any
condensation that may have accumulated in the
hose.
Screws
Temperature
switch
Ground
clip
Control
mounting
plate
Control hood
rear panel
clip
Pressure
switch
Screw
Speed
switch
Timer
Screw
Screw
End panel
(right side)
Screw
©2005 Maytag Services