Water Level Pressure Switch; Air Dome Hose - Maytag Neptune MAH3000 Service Manual

WATER LEVEL PRESSURE
SWITCH
The water pressure switch is located in the
console area and mounted to a galvanized
bracket secured to the rear panel of the con-
sole. The air dome hose is inserted into the
lower end of the mounting bracket (Figure
6-2) . The nipple of the pressure switch is in-
serted into the end of the air dome hose which
is secured by the lower mounting bracket.
Bracket
Pressure
Switch
B) Rotate
Switch
Air Dome
Hose
Figure 6-2
R E M O V A L
1 . Disconnect power to the unit.
2 . Remove the console (See Console
Removal) .
3 . Slide the pressure switch up, away from
the air dome hose.
4 . Remove wire harness from the pressure
switch.
5 . Rotate the pressure switch 90 degrees to
disengage locking tabs on the back of the
switch from the mounting bracket.
6 . The mounting bracket for the pressure
switch is secured to the rear console panel
with one screw.
16008373-01
A) Slide
Switch Off
© 1998 Maytag Corporation
7. To replace, insert air dome hose into the
bracket. Insert the pressure switch nipple
into the air dome hose. Press the pres-
sure switch into the bracket until it "snaps"
into place.

AIR DOME HOSE

The air dome hose connects the pressure
switch to the air dome located in the sump
area of the outer tub. Routing of the air dome
hose passes from the console down the rear
wall of the cabinet to the rear sump area of
the outer tub. Two holding clips retain the air
dome hose to the cabinet away from the belt
and pulley.
REMOVAL FROM CONSOLE
1 . Disconnect power to the unit.
2 . Remove the console (See Console
Removal).
3 . Slide the pressure switch up on the mount-
ing bracket, away from the air dome hose.
The mounting bracket for the pressure
switch is secured to the rear panel of the
console (See Figure 6-2).
4 . Pull the air dome hose down through the
top cover opening.
REMOVAL FROM OUTER TUB
1 . Disconnect power to the unit.
2. From behind the outer tub, slide off the
retainer clip securing the air dome hose
to the rear spout of the outer tub.
3 . Remove one of the rear baffles.
4 . Grasp and lift the airdome hose from the
sump area (See Figure 6-3).
SECTION 6. WATER CARRYING COMPONENTS
6-2