Led Behavior For The Gateways - Banner DX80G9M6S-P2 Quick Start Manual

SureCross Performance Gateway
Discrete Input Wiring for PNP Sensors
PWR
10-30V dc
DIx
Wiring Diagrams for Discrete Outputs
Connecting dc power to the communication pins will cause permanent damage. For the DX8x...C models, PWR in the wiring diagram refers to V+ on the wiring board and
GND in the wiring diagram refers to V- on the wiring board.
Discrete Output Wiring (PNP)
PWR
DOx
Load
GND
Wiring Diagrams for Analog Inputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs. Only connect sensor outputs to
analog inputs.
Analog Input Wiring (10 to 30V dc Power)
PWR
10-30V dc
AIx
+ −
sensor
GND
dc common
Wiring Diagrams for Analog Outputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs. Only connect sensor outputs to
analog inputs.
Analog Output Wiring
PWR
AOx
sensor
GND

LED Behavior for the Gateways

After powering up and binding the Gateway and its Nodes, verify all devices are communicating properly. When testing communication between the Gateway and Node, all
radios and antennas should be at least two meters apart or the communications may fail. This table lists the LED behavior for the Gateway models with two LEDs.
LED 1
(solid green)
(flashing red)
P/N 155861 Rev. D
10-30V dc
dc common
Analog Input Wiring (4–20mA, 2-Wire, Externally
Powered Sensors)
+
external power
sensor
dc common
10-30V dc
dc common
LED 2
(flashing red)
www.bannerengineering.com - tel: 763-544-3164
Discrete Input Wiring for NPN Sensors
DIx
GND
dc common
Analog Input Wiring (4–20mA, 2-Wire, Switch Pow-
ered Sensors)
AIx
−
GND
dc common
(Only possible in models with switch power (SPx) out-
puts)
Gateway Status
Power ON
Device Error
SPx
+
AIx
−
+ −
sensor
GND
5