Taylor-Dunn C0-426-48AC Service And Replacement Parts Manual page 22

Tool List
Tool List
The tools shown here are generic for servicing Taylor-
Dunn vehicles. Not all tools will be required for servicing
this vehicle.
62-027-32: Throttle Module Analyzer
Tests the throttle module in or out of the
vehicle
Curtis AC System Handset. Diagnostics and
adjustments of the Curtis AC control system.
62-027-67: Diagnostics and adjustments
62-027-68: Diagnostics only
Controller Programming:
Curtis AC: 62-027-66 "1314 PC Programming
Station"
70-440-55: Pin Removing Tool
Removes pin from Amp circular harness
connectors.
Page 22
75-089-00: Throttle Module Test Harness
Used in conjunction with a volt meter to test
the throttle module. The module must be
installed in a working control system.
Note: Part # 62-027-31 includes instructions
Molex # 11-300-02: Pin Removing Tool
Removes 0.062 diameter pins from Molex
rectangular harness connectors. Not
available from Taylor-Dunn. Purchase from
any local electronics distributor.
75-442-55: Pin Removing Tool
Removes pins from Molex Mini-Fit harness
connectors.
62-027-00: Test Light
Used for testing electrical circuits. Switchable
for 12, 24, 36, 48 volt systems.
Required to complete troubleshooting
provided in the vehicle service manuals.
Molex # 11-300-06: Pin Removing Tool
Removes 0.093 diameter pins from Molex
rectangular harness connectors. Not
available from Taylor-Dunn. Purchase from
any local electronics distributor.
MC-425-15
C-426