Installing The Optional Ac Inlet - Honeywell NetAXS NX4L1 Installation Manual

9. Apply power to the panel. The power-up sequence may take up to two minutes, after which the
RUN LED blinks green. The RUN LED is located near Terminal Block (TB) 8. After the power-up
sequence, check the LEDs to be sure the panel has powered up properly (see
page 58).
10. Configure the panel by following the instructions in the NetAXS™ Access Control Unit User's
Guide.
11. If you are using a battery backup function, place the two 7 Ah batteries in the enclosure with the
battery terminals of each battery close to each other.
12. Attach the 4-inch battery-to-battery cable from the positive (red) terminal of one battery to the
negative (black) terminal of the other battery. DO NOT CONNECT THE CABLE BETWEEN
THE TERMINALS OF THE SAME BATTERY.
13. Attach the positive (red) power supply-to-battery cable to the remaining positive (red) battery
terminal.
14. Attach the negative (black) power supply-to-battery cable to the remaining negative (black)
battery terminal.
15. For panels using the Ethernet connection, the cable clamp (HAS part number 3-000342) must be
used for the panel to pass the FCC Part 15 Class B requirements. Snap the clamp around any
portion of the Ethernet cable that is inside of the enclosure.

4.1 Installing the Optional AC Inlet

Perform these steps to install the optional AC inlet (HAS part number 100-00049):
1. Remove the knockout piece at the lower-left side of the enclosure.
2. Feed the AC inlet assembly wires through the opening from the outside.
3. Push the receptacle straight in, until it snaps into place.
4. Connect each colored wire to its corresponding color on the terminal block.
5. Plug the AC inlet unit's power cord into the three-prong receptacle.
6. Plug the other end of the cable into a standard non-switched 115 VAC outlet.
Use only a Honeywell-provided power cord (HAS part number 700-0109). UL has evaluated the
Note:
use of this power cord with the optional AC inlet for the NX4L1.
NetAXS™ NX4L1 Access Control Unit Installation Guide, Document 7-901099V3
NetAXS™ NX4L1 Installation Guide
"LED Operation" on
Installation
21