Flip up dash monitor mount for 2015-2017 dodge charger police pursuit with mini display, 2018-2020 dodge charger police pursuit and charger sxt (5 pages)
Ip rated docking station & tablet cases for dell latitude 7030/7230 rugged extreme tablet (20 pages)
Summary of Contents for Havis C-DMM-3005
Page 1
CM008582 2 1/4" Plastic washer CM86600 2 1/4" Steel washer GSM31005 2 1/4" Nylock nut GSM30016 Notes: The C‐DMM‐3000 swivel plate accepts C‐MM‐301 offset bracket used with C‐MM‐2XX adaptors. C‐MM‐2XX series adaptor brackets are not needed for most VESA 75 and other Havis Docking Station mounting applications. CM009068 VESA rotator plate gives additional positioning options, but is not required depending on mounting preference. Always ! Read all instructions before installing any Havis, Inc. products. Check for obstructions (Wires, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit C‐DMM‐3005_INST_8‐18 ...
Page 2
C‐DMM‐3005 Assembly CM009444 Passenger side support bracket CM009445 CM009446 Driver side Side mounting bracket support bracket GSM31005 – Flat washer CM86600 – Nylon flat washer GSM30016 – Nylock nut GSM33117 ‐ 10‐32 x 3/8 Machine screw GSM31003 ‐ #10 flat washer CM009068 For attaching side mounting brackets to VESA 75 rotator plate main frame (not shown) CM008582 PVC spacer GSM31003 – Flat washer GSM30015 – Nylock nut washer C‐DMM‐3005_INST_8‐18 ...
Page 3
Dodge Charger Dash Gently pry along the dash with a flat blade panel Prior to installation. removal tool. Slowly working along the frame. Temporarily remove radio touch screen. Dash panel partially removed. NOTE: The touchscreen has a theft deterrent system built in so we suggest leaving the main power plugged in. Phillips screwdriver. Temporarily remove two (2) OEM screws and Repeat process for both sides. attach support bracket with OEM screw as shown. Make sure brackets fit around radio snug. 10mm socket. C‐DMM‐3005_INST_8‐18 ...
Page 4
Reinstall the radio touch screen using the Attach side mounting brackets to the side support previously removed OEM hardware. brackets using 10‐32 nylock nuts and flat washers. Repeat process for driver side and tighten hardware. Carefully reinstall previously removed dash panel. Attach main C‐DMM‐3005 frame to the side support Make sure the side mounting brackets are brackets using 10‐32 x 3/8” screws and star washers. even along the dash and the dash is fully seated back into place. C‐DMM‐3005_INST_8‐18 ...
Page 5
Attach the rotator plate to the swivel using large PVC Attach VESA rotator plate to the mounting bracket washer, 1/4 nylon washers, metal washers, and nylock of the device you are attaching. nuts and stop nuts. Confirm smooth operation of the C‐DMM‐3005. Attach the dock to the mounting bracket (with hardware supplied with dock). Run wires as desired. Installation is now complete. Double check all hardware, latching and wire harness clearance. C‐DMM‐3005_INST_8‐18 ...