D-Link DIR-853 User Manual page 93

DIR-853 AC1300 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port 3.0
User Manual
Figure 75. The page for creating a new
Parameter
NAT
Firewall
RIP
Ping
Isolate connection
When all needed settings are configured, click the APPLY button.
PPPoE IPv6
Miscellaneous
For the PPPoE Dual Stack type only.
If the switch is moved to the right, the network address translation
function is enabled. Do not disable the function unless your ISP
requires this.
If the switch is moved to the right, protection against external
connections for the LAN devices is enabled (for example, against
attempts to get information about the LAN devices or to hack a
device from the LAN). For security reasons, it is recommended not
to disable this function.
Move the switch to the right to allow using RIP for this connection.
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
If the switch is moved to the right, the router uses an alternate
routing table for this connection. Enable this function only when
your ISP requires this.
Page 93 of 228
Configuring via Web-based Interface
connection. The Miscellaneous section.
Description