D-Link DIR-853 User Manual page 192

DIR-853 AC1300 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port 3.0
User Manual
Parameter
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Destination port
Set source port
manually
Source port
Click the APPLY button.
To edit a rule for IP filtering, select the relevant line in the table. On the opened page, change the
needed parameters and click the APPLY button.
To remove a rule, select the checkbox located to the left of the relevant line of the table and click
the DELETE button (
The destination host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
The destination host end IPv4 or IPv6 address.
The destination subnet IPv4 or IPv6 address. The field is displayed
when the Subnet value is selected from the Set as drop-down list.
A port of the destination IP address. You can specify one port,
several ports separated by a comma, or a range of ports separated by
a colon.
Move the switch to the right to specify a port of the source IP
address manually. Upon that the Source port field is displayed.
A port of the source IP address. You can specify one port, several
ports separated by a comma, or a range of ports separated by a colon.
). Also you can remove a rule on the editing page.
Page 192 of 228
Description
Ports
Configuring via Web-based Interface