D-Link DIR-853 User Manual page 172

DIR-853 AC1300 MU-MIMO Wi-Fi Gigabit Router
with 3G/LTE Support and USB Port 3.0
User Manual
In the opened window, you can specify the following parameters:
Parameter
Protocol
Interface
Destination network
Destination netmask
Gateway
Metric
After specifying the needed parameters, click the SAVE button.
To edit an existing route, select a relevant line of the table. In the opened window, change the
needed parameters and click the SAVE button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the DELETE button (
An IP version.
From the drop-down list, select an interface (connection) through
which the device will communicate with the remote network. If you
have selected the Auto value, the router itself sets the interface
according to the data on the existing dynamic routes.
A remote network which can be accessed with help of this route. You
can specify an IPv4 or IPv6 address.
The format of a host IPv6 address is 2001:db8:1234::1, the
format of a subnet IPv6 address is 2001:db8:1234::/64.
For IPv4 protocol only.
The remote network mask.
An IP address through which the destination network can be accessed.
A metric for the route. The lower the value, the higher is the route
priority. Optional.
).
Page 172 of 228
Configuring via Web-based Interface
Description