Table of Contents
Advertisement
Electrical connection UK
Electrical connection
All work on the electrical con-
nection must be carried out by Miele,
a Miele authorised technician or a
qualified electrician.
– In the UK it must comply with BS
7671.
– The connection to the power supply
must comply with national regula-
tions (plug and socket must be ac-
cessible for service and maintenance
work after the machine has been in-
stalled). An electrical safety test must
be carried out after installation and
after any service work.
– If the dishwasher is hard wired to the
power supply, connection should be
made via a mains switch with all-pole
isolation. The mains switch must en-
sure a 3 mm gap between all open
contacts, and must be able to be
locked in the off position.
– Equipotential bonding should be car-
ried out if required.
– If replacing the mains cable, use only
original Miele replacement parts or a
suitable cable with core cable ends.
– For technical data see data plate or
wiring diagram supplied.
The machine must only be operated
with the voltage, frequency and fusing
shown on the data plate.
This machine can be converted to a
different type of power supply in ac-
cordance with the conversion diagram
and wiring diagram supplied.
72
Converting the machine to a different
type of power supply can lead to
longer programme durations, result-
ing in increased energy consump-
tion.
The values declared on the label will
only be achieved if the machine re-
mains in the state in which it was de-
livered.
The data plates are located at the back
of the dishwasher and along the right
edge of the open door.
The wiring diagram is supplied with
the machine.
The conversion diagram is attached to
the plinth panel behind the plinth cover.
Equipotential bonding connection
There is a screw connection point
marked at the back of the appliance,
to which additional equipotential bond-
ing can be connected.
Advertisement
Table of Contents
