Logging Measurements; Hold; Filter - Fluke 1630-2 User Manual

1630-2/1630-2 FC
Users Manual

Logging Measurements

The Clamp records data over time and saves >2000
measurements in memory at the set logging interval.
To start logging measurements, push . The display shows
 to indicate that measurement logging is in progress See
Figure 10.
Figure 10. Logging Measurements
Measurements are recorded at the sampling interval you
specified. See Log Interval on page 8 for more information.
Logging stops when:
• Clamp memory is full
• Clamp detects a low battery
• You push  again
If the sampling interval is set at 0 seconds, only one
data point is recorded. To record the next data point,
press  again. The memory location is also
displayed for about 1 second.
16
AC
Note

Hold

Push  to freeze the measurement value on the display.
Push  again to continue and take measurements.

Filter

Push  to toggle the filter on and off in the leakage current
measurement mode. When  shows on the display, the
clamp can isolate the 50/60 Hz fundamental frequency from
the harmonics.