DFI PL610-C622 User Manual page 32

SATA Configuration
This section is designed to select the SATA controller and the type of hard disk drive which are
installed in your system unit.
InsydeH2O Setup Utility
Advanced
SATA Confi guration
 PCH SATA Confi guration

PCH sSATA Confi guration
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter

InsydeH2O Setup Utility
Advanced
PCH SATA Confi guration
SATA Controller <Enabled>
SATA Speed <Auto>
Confi gure SATA as <AHCI>
SATA3_0 [Not Installed]
SATA Port <Enabled>
Hot Plug <Disabled>
SATA3_1 [Not Installed]
SATA Port <Enabled>
Hot Plug <Disabled>
SATA3_2 [Not Installed]
SATA Port <Enabled>
Hot Plug <Disabled>
SATA3_3 [Not Installed]
SATA Port <Enabled>
Hot Plug <Disabled>
SATA3_4 [Not Installed]
SATA Port <Enabled>
Hot Plug <Disabled>
SATA3_5 [Not Installed]
SATA Port <Enabled>
Hot Plug <Disabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter

Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
SATA devices and settings
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Rev. 5.0
Enable or Disable SATA
Controller
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Advanced
PCH sSATA Confi guration
SATA Controller
SATA Speed
M.2 slot
SATA Port
Hot Plug
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item

SATA Controller
This field is used to enable or disable Serial ATA device(s).
SATA Speed
This field is used to select SATA speed generation limit: Auto, Gen1, Gen2 or Gen3.
Configure SATA as
The mode selection determines how the SATA controller(s) operates.
AHCI
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-
face).
RAID
This option allows you to create RAID or Intel Matrix Storage configuration on Serial
ATA devices.
SATA Port and Hot Plug
These fields are used to enable or disable the serial ATA ports and their hot plugs.
32
InsydeH2O Setup Utility Rev. 5.0
Enable or Disable SATA
Controller
<Enabled>
<Auto>
[Not Installed]
<Enabled>
<Disabled>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com