DFI PL610-C622 User Manual page 36

SIO AST2500
This section configures the system super I/O chip parameters.
InsydeH2O Setup Utility
Advanced
Serial Port A <Enable>
Base I/O Address <3F8>
Interrupt <IRQ4>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter

Serial Port A
Configure the settings to use the serial port.
Disable No configuration
Enable User confi guration
Chapter 3 BIOS Setup
Chapter 3
Confi gure Serial port using
options: [Disable] No Con-
figuration [Enable] User
Confi guration [Auto] EFI/
OS chooses confi guration
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

H2O IPMI Configuration
This section configures the H2O IPMI (Intelligent Platform Managment Interface).
Advanced
IPMI Support
BMC Warm Up Time
System Interface Type
IPMI Base Address for OS
IPMI Base Address for POST
IPMI Base Address for SMM
BMC Status
BMC Firmware Version
IPMI Specifi cation Version
BMC MAC Address
ACPI SPMI Table
Boot Option Support
Case Open Status
Case Open Alert
Clean Case Open Status
 BMC Confi guration

SDR List
Execute H2O IPMI Utility
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item

IPMI Support
Enable or disable IPMI Support.
BMC Warm Up Time
Set the max. waiting time period from POST to BMC ready in seconds.
ACPI SPMI Table
Enable or disable the ACPI SPMI Table for IPMI driver installation.
Boot Option Support
Enable or disable IPMI boot option function.
Case Open Alert
Enable or disable buzzer beep when case is open. When disabled, system will clean
case open status.
Clean Case Open Status
Select this field and press Enter, system will clean the case open status.
36
InsydeH2O Setup Utility Rev. 5.0
Enable/Disable IPMI Sup-
<Enabled>
port. Note: If changing to
enable, BMC detailed in-
[60]
formation only valid after
KCS
rebooting.
CA2/CA3
CA2/CA3
CA2/CA3
OK
B187.06A
2.0
00:C0:A8:12:34:58
<Enabled>
<Enabled>
CLOSE
<Disabled>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com