DFI PL610-C622 User Manual page 34

InsydeH2O Setup Utility
Advanced
PCIE1
Port Enabled <Auto>
PCIe Speed <Auto>
Hot Plug <Disabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→  Select Item Enter
Port Enabled
This field is used to enable or disable the PCI Express Root Port.
PCIe Speed
Select the speed of the PCI Express Root Port: Auto, Gen1 (2.5 GT/s), Gen2 (5 GT/s)
or Gen3 (8 GT/s).
Hot Plug
This field is used to enable or disable the PCI Express Hot Plug.
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
In auto mode the BIOS
will remove the EXP port
if there is no device or er-
rors on that device and the
device is not HP capable.
Disable is used to disable
the port and hide its CFG
space.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Debug Configuration
This section configures Debug setting.
Advanced
Debug Confi guration
Dynamic EFI DEBUG <Off>
F1 Help ↑/↓ Select Item
Esc Exit ←/→  Select Item
Dynamic EFI DEBUG
This field is used to turn on or off the function to output debug message from COM
port. If set to on, relevant EFI debug configurations will show up.
Advanced
Debug Confi guration
Dynamic EFI DEBUG <On>
EFI debug print level [0x8000004F]
EFI debug serial port [0x3F8]
EFI debug baud rate [115200]
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item

34
InsydeH2O Setup Utility Rev. 5.0
Enable it to output debug
message from COM port.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

InsydeH2O Setup Utility Rev. 5.0
Enable it to output debug
message from COM port.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com