DFI PL610-C622 User Manual page 41

When Console Serial Redirect is set to enabled, the screen will appear like below:
InsydeH2O Setup Utility
Advanced
Console Redirection Setup
Console Serial Redirect <Enabled>
Terminal Type <VT_100>
<115200>
Baud Rate
Data Bits <8 Bits>
Parity <None>
Stop Bits <1 Bit>
<None>
Flow Control
 COM_A
Enable VT-100, 115200, N81
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→  Select Item Enter
Terminal Type
Select terminal type: VT_100, VT_100+, VT_UTF8 or PC_ANSI.
Baud Rate
Select baud rate: 115200, 57600, 38400, 19200, 9600, 4800, 2400 or 1200.
Data Bits
Select data bits: 7 bits or 8 bits.
Parity
Select parity bits: none, even or odd.
Stop Bits
Select stop bits: 1 bit or 2 bits.
Flow Control
Select flow control type: none, RTS/CTS or XON/XOFF.
Chapter 3 BIOS Setup
Chapter 3
Rev. 5.0
Enable Console Redirec-
tion Function
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

COM_A
Advanced
COM_A
PortEnable
UseGlobalSetting
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item

PortEnable
This field is used to enable or disable the COM port to redirect the console.
UseGlobalSetting
This field is to enable or disable to use global setting. When enabled the global set-
ting, setting of the COM port will be the same as those in Console Redirection section.
When disabled the global setting, setting of the COM port can be configured indepen-
dently in this section.
41
InsydeH2O Setup Utility Rev. 5.0
<Enabled>
<Enabled>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com