External Control Connection Terminals, Frames R6 - ABB ACH580-01 Hardware Manual


External control connection terminals, frames R6...R9
The layout of the external control connection terminals of frames R6...R9 is shown
below.
R6...R9
3
X1:1...3
X1:4...6
X1:7...9
X2
X3:1...3
X3:4...6
X4
X16 X17
X12
WARNING!
control board is powered using an external 24 V AC supply.
Operation principle and hardware description 45
1
2
X13
X5
S4, S5
X14
Do not connect the +24 V AC cable to the control board ground when the
Description
X1 Analog inputs and outputs
X2 Aux. voltage output
X3 Digital inputs
X4 Safe torque off connection
X5 Connection to embedded EIA-
485 fieldbus adapter module
X6 Relay output 3
X7 Relay output 2
X8 Relay output 1
X10 External +24 V AC/DC input
connection
X12 Panel connection
X13 Option slot 1 (fieldbus adapter
modules)
X14 Option slot 2 (I/O extension
modules)
X16 Auxiliary fan 1 connection
X17 Auxiliary fan 2 connection
S4, S5 Termination switch (S4), bias
resistor switch (S5), see section
Switches
Switches
America)
X10
1 Panel port (control panel
connection)
X8
2 Cold configuration connection.
This connector is used with the
X7
CCA-01 configuration adapter.
X6
3 Power OK and Fault LEDs. See
section
on page 146 (IEC) or
on page 146 (North
LEDs on page 240.