Circuit Breaker; Blade Replacement, Taping Head - 3M -Matic 700a Instructions And Parts List

Maintenance
(Continued)
WARNING – Turn off electrical power supply and disconnect power cord from electrical supply
before beginning maintenance. If power cord is not disconnected, severe injury to personnel
could result.

Circuit Breaker

The case sealer is equipped with a circuit breaker
which trips if the motors are overloaded. Located
inside the electrical enclosure on the side of the
machine frame just below the machine bed, the
circuit breaker has been pre-set at 2.2 amps and
requires no further maintenance.
If circuit is overloaded and circuit breaker trips,
unplug machine from electrical power:
1. Determine cause of overload and correct.
2. Remove electrical enclosure cover.
3. Press "Reset" and then press "On" button.
If circuit breaker will not reset, wait 2
minutes and retry.
4. Replace cover.
5. Plug in machine.
6. Press machine "On" button to resume case
sealing.

Blade Replacement, Taping Head

See Section II, "Maintenance – Blade
Replacement", page 9.
20