The Adjustment Of Splicing Detector - Siruba ASL-JBH200C Original Instructions Manual

接頭檢測的調整
接頭檢測板①下降的時候，與接頭檢測承軸②
之間的間隙，大約為布料厚度的 3~4 倍。 接
入空氣，按著重設按鈕的同時打開電源開關，
調整會變得容易操作。（調整後，關閉電源）
【調整方法】
⑴微調的情況
鬆開閉鎖螺絲③，旋動調整螺絲來進行調
整。
⑵進行大量調整的情況
鬆開螺絲④，將把手⑤沿著箭頭方向移動
進行調整。
③
P12
THE ADJUSTMENT OF SPLICING
DETECTOR
As splicing detector plate ① getting lower,
its gap between splicing detector shaft ② is
about three or four times thickness of fabric.
Put into air, press Reset switch and turn the
power on simultaneously, which could make
operation easier. （Turn off power after
adjustment.）
【Adjustment】
⑴Fine adjustment
Loosen lockscrew ③, turn adjusting screw
for fine adjustment.
⑵Large adjustment
Loosen screw ④, move handle ⑤ to the
arrow direction for adjustment.
② ①
④
⑤
布料厚度 ×( ３～４)
Thickness of fabric ×( ３～４)