Pioneer SGX-CA600 User Manual page 82

Uploading
1
Install theCyclo-Sphere Control App on your iPhone or
Android device.
https://cyclo-sphere.com/app/
2
Link the Cyclo-Sphere Control App and your device.
Operate the Cyclo-Sphere Control App to display your device from [Add
a new device] and then configure the link setting.
3
Select the following in order in the Cyclo-Sphere Control
App.
[SGX-CA600] > [Log Data upload settings]
4
Tap [Upload via smartphone] in the Cyclo-Sphere Control
App.
5
Check that authentication is complete for [Cyclo-Sphere
Account Setting] in the Cyclo-Sphere Control App.
If authentication is not complete, configure the account settings.
Note
! If there is log data that has not been transfered via Wi-Fi before the start
of logging or after the saving of log data while the device and Cyclo-
Sphere Control App are linked, the log data is transferred to the Cyclo-
Sphere Control App via Bluetooth automatically.
! Transferred log data is transferred from the Cyclo-Sphere Control Appto
Cyclo-Sphere automatically using the phone line or Wi-Fi connection.
! To turn off automatic transfer from the Cyclo-Sphere Control App using
the phone line in order to limit transfer to when there is a Wi-Fi connec-
tion, turn on the following setting.
[Others] > [Cyclo-Sphere Control Setting] > [Limit data communication
such as file transmission via Wi-Fi.]
! Automatic transfer to Cyclo-Sphere may not be possible depending on
the line connection status of the smartphone.
! It takes approximately 3 minutes per MB when transferring from the
device to the Cyclo-Sphere Control App.
When there is about 5 hours of log data, it will take approximately 15
minutes for transfer to complete.
82