Pioneer SGX-CA600 User Manual page 261

Gps cycle computer
Hide thumbs Also See for SGX-CA600:
Table of Contents

Advertisement

Setting item
Enable
Sensor Name
Status
Device Number
Battery
Manufacture ID
Delete
When ANT+power meter is connected
Setting item
Zero Calibration
Balance Setting
Description
Enable or disable the sensor.
Enter the sensor name.
Display the searching, connected, and disabled statuses.
Display the device number of the sensor.
Display the voltage value or battery status.
! New: New battery
! Good: Good state
! OK: Normal
! Low: Low
! Critical: Cannot be used
"--" is displayed when the sensor is not supported or
before the measurement data of the status is received.
This item is not displayed for a sensor that does not
support display.
Display the manufacturer ID or name of the sensor.
This item is not displayed for a sensor that does not
support display.
Delete this sensor from the sensor list.
Description
Perform zero point calibration.
The status, result, and data are displayed.
When a ANT+power meter that supports auto zero point
calibration is connected, the auto zero point check box
can be selected.
The torque values are displayed for a ANT+power meter
that supports torque value display.
Select this check box to enable the balance settings.
Enter the left/right balance. Select the left sensor or right
sensor for the sensor type.
A power value that is double on the sensor side is cor-
rected from the entered left/right balance and sensor
type.
261

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents