Pioneer SGX-CA600 User Manual page 321

Low Energy Mode
Auto Sleep
Auto Power Off
Altitude Calibration
Enable* or disable the power saving mode and set a
battery threshold value.
When the power saving mode is enabled, if the remaining
battery level drops to below the threshold value, a mes-
sage appears and then the device switches to the power
saving mode after approximately 10 seconds.
The settings are automatically adjusted so that the possi-
ble operating time becomes longer.
In power saving mode, Bluetooth connection does not
function and LCD does not display information.
Turn on the LCD display by pressing any button other
than [←] and [→].
The factory setting is [10%].
Enable* or disable auto sleep and set the time until auto
sleep.
When auto sleep is enabled, if there is no button oper-
ation or riding within the set time before logging starts
or during auto pause, a message appears and then the
device sleeps after approximately 10 seconds.
When the auto power off setting is enabled, if the sleep
state continues within the set time, the power is automati-
cally turned off from the sleep state.
The device will wake up automatically when the
power value or cadence value of the pedaling monitor,
ANT+power meter, or ANT+smart trainer becomes valid.
When it becomes valid, the device may take a while to
wake up if it has been asleep for one minute or more.
Enable* or disable auto power off and set the time until
auto power off.
When auto power off is enabled, if there is no button
operation or riding within the set time, a message
appears and then the device powers off after approxi-
mately 1 minute.
Enable* or disable auto GPS altitude correction and
set the correction method (current altitude*/sea level
pressure/GPS).
You can also check the current altitude.
Calibration can also be performed manually.
321