Pioneer SGX-CA600 User Manual page 228

10
Check that "Success" is displayed on the screen of the
device and then press the [Confirm] button.
If you changed the mode to the pedaling monitor mode, the sensors are
added to the sensor list and establishing a connection starts.
11
Check the LEDs of the sensors.
When the mode is successfully changed, the LEDs of the sensors light.
! Pedaling monitor: Lights green for 10 seconds
! Dual power: Lights orange for 10 seconds
! Single power: Flashes orange for 10 seconds
If [Success] is not displayed
! Timeout: Communication conditions are poor.
Check that the sensors to be connected are running and then bring the
device near to the sensors and perform the connection operation again.
If the problem is still not resolved, move sufficiently away from devices
such as a Wi-Fi or other wireless LAN device, or a microwave oven,
and then try the connection operation again.
! Battery has run out of power: The battery power is consumed.
Remove the battery and replace it with a new one.
Magnet calibration
Magnet calibration is an important task to ensure that the pedaling monitor sensors
can detect and accurately measure the magnet positions.
228