Cleaning And Sanitizing The Machine Parts; Assembly Of Machine - Stoelting E122 Operator's Manual

3.5 CLEANING AND SANITIZING THE
MACHINE PARTS
Place all loose parts in a pan or container and take to
the wash sink for cleaning. Local and state health codes
dictate the procedure required. Some health codes require
a four-sink process (pre-wash, wash, rinse, sanitize, and
air-dry), while other codes require a three-sink process
(without the pre-wash step). The following procedures
are a general guideline only. Consult your local and state
health codes for procedures required in your location.
A. Set up a 3-compartment sink with wash, rinse and
sanitize compartments. Use Stera-Sheen Green
Label or equivalent. Prepare sanitizer according
to manufacturer's instructions to provide a 100ppm
strength solution. Set aside a small amount of
sanitizer
B. Clean all parts using brushes provided.
C. After cleaning, remove the parts and let air dry.
D. Sanitize the hopper and freezing cylinder with
sanitizer. Be sure to clean the rear seal surfaces
inside the freezing cylinder.
E. Wipe down the outside of the machine and table
with a yellow sanitized towel.
CAUTION
Do not allow sanitizer to remain in contact with
stainless steel parts for prolonged periods. Pro-
longed contact of sanitizer with machine may cause
corrosion of stainless steel parts.
Torque
Rod
Owner's Manual #513667

3.6 ASSEMBLY OF MACHINE

To assemble the machine parts, refer to the following steps:
A.
B.
C.
D.
E.
F.
Auger
Support
Bushing
Stator Bar
Stator Bar
Front O-Ring
Figure 3-6 Door and Stator Assembly
12
NOTE
Petrol Gel sanitary lubricant or equivalent must be
used when lubrication of parts is specifi ed.
NOTE
The United States Department of Agriculture and
the Food and Drug Administration require that lubri-
cants used on food processing equipment be certi-
fi ed for this use. Use lubricants only in accordance
with the manufacturer's instructions.
Wash, rinse, dry and sanitize hands before
starting.
Place the rear seal o-ring onto the auger and
apply a thin fi lm of Petrol-Gel to the o-ring.
Assemble the rear seal onto the auger with the
large end of the seal to the rear. Lubricate the hex
end of the auger with a small amount of spline
lubricant.
Install the plastic auger blade onto the auger. Push
the auger into the freezing cylinder and rotate it
slowly until the auger engages the drive shaft.
Assemble the o-rings onto the spigot body and
apply a thin fi lm of Petrol-Gel onto the o-rings.
Insert the spigot body into the front door.
Stator Bar
Bushing
Stator Bar
Rear O-Ring
E122 & F122 Model Machines
Quad
Ring