Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Stoelting E122
Summary of Contents for Stoelting E122
- Page 1 Model E122 & F122 OPERATORS MANUAL Manual No. 513667 Rev.4...
- Page 3 DO NOT ATTEMPT to operate the machine until instructions and safety precautions in this manual are read completely and are thoroughly understood. If problems develop or questions arise in connection with installation, operation, or servicing of the machine, contact Stoelting. Stoelting Foodservice Equipment...
- Page 4 CAUTION If you need to replace a part, use genuine Stoelting The signal word “CAUTION” indicates a potentially parts with the correct part number or an equivalent hazardous situation, which, if not avoided, may result part.
-
Page 5: Table Of Contents
Auger Shaft and Faceplate Parts ............... 22 Hopper Parts ....................24 Auto Fill Parts ..................... 25 Special Applications Application of Stoelting F122 and Arctic Quake Non-Dairy Concentrate ..27 Warranty Warranty of Mix Transfer Pumps / Cocktail / Slush ........31... -
Page 7: Description And Specifi Cations
SECTION 1 DESCRIPTION AND SPECIFICATIONS DESCRIPTION The Stoelting E122 & F122 countertop machines are grav- ity fed. The machines are equipped with fully automatic controls to provide a uniform product. This manual is designed to help qualifi ed service personnel and opera- tors with the installation, operation and maintenance of the Stoelting E122 &... -
Page 8: Specifi Cations
Two - 1/3 hp Air Flow Air cooled units require 4” (10,2 cm) air space in back Hopper Volume Two - 3 gallon (11,36 liters) Freezing Cylinder Two - 1.25 gallon (4,73 liters) Volume Owner’s Manual #513667 E122 & F122 Model Machines... - Page 9 14.5A connection type NEMA6-20P power cord provided Compressor 12,000 Btu/hr Drive Motor Two - 1/2 hp Air Flow Air cooled units require 6” (15,24 cm) air space on both sides Owner’s Manual #513667 E122 & F122 Model Machines...
- Page 10 Owner’s Manual #513667 E122 & F122 Model Machines...
-
Page 11: Installation Instructions
10 days and request inspection. The customer must place claim for damages and/or shortages WARNING in shipment with the carrier. Stoelting cannot make any claims against the carrier. Do not alter or deform electrical plug in any way. -
Page 12: Auto Fill Pump Installation
SETTING MODEL INFORMATION Press the Main Power button. The display will ask if the machine is an E122 or F122. Use the arrow buttons to move the cursor to the correct model and press the SEL button. SETTING CONTACT INFORMATION Plug your USB fl... - Page 13 Press the left arrow button until the Current Status screen is displayed. Figure 2-6 Press the left arrow button to go back to the Current Status screen and remove the USB fl ash drive. Owner’s Manual #513667 E122 & F122 Model Machines...
- Page 14 Owner’s Manual #513667 E122 & F122 Model Machines...
-
Page 15: Initial Set-Up And Operation
Do not operate under unsafe operating conditions. Never operate the machine if unusual or excessive noise or vibration occurs. IntelliTec2 Control Consistency Adjustment Screw Figure 3-1 F122 Controls Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 16: Removing Mix From Machine
The arrow buttons are used by service technicians to Fill the hopper with the 2 gallons of sanitizer navigate through the control readings and settings. solution. Press the clean button. Run the machine in Clean mode for approximately 5 minutes. Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 17: Disassembly Of Machine Parts
Remove the drain tray, drip tray and drip tray grid. Remove the hopper cover and disconnect the autofi ll adapter from the cover by pulling out the retaining clip. Figure 3-4 Spigot and Ice Breaker Bar Removal Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 18: Cleaning And Sanitizing The Machine Parts
Torque Stator Bar Auger Bushing Support Bushing Stator Bar Quad Stator Bar Ring Rear O-Ring Stator Bar Front O-Ring Figure 3-6 Door and Stator Assembly Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 19: Sanitizing
2 gallons (7.5 liters) of 90° to 110°F (32° to 43°C) water. Allow sanitizer to contact the surfaces to be sanitized for 5 minutes. Any sanitizer must be used only in accordance with the manufacturer’s instructions. Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 20: Freeze Down And Operation
Do not use highly abrasive materials as they will mar the fi nish. 3.11 PREVENTIVE MAINTENANCE Stoelting recommends that a maintenance schedule be followed to keep the machine clean and operating properly. B. DAILY The exterior should be kept clean at all times to preserve the luster of the stainless steel. - Page 21 The pump is now ready to operate. Place the Lubricate condenser fan motor with S.A.E. 20 hopper cover on the hopper. weight oil. Three to six drops is required. Sanitize the autofi ll system following the steps below: Owner’s Manual #513667 E122 & F122 Model Machines...
-
Page 22: Extended Storage
NOTE Do not leave cleaning solution in the hopper or in the freezing cylinder during the shutdown period. Remove, disassemble and clean the front door, mix inlet regulator and auger parts. Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 23: Troubleshooting Error Codes
Check the sides of the machine for anything that would restrict airfl ow. Clean If the error persists after attempting to clear it, Freezing Cylinder Sensor contact your Authorized Stoelting Distributor for Hopper Sensor (single hopper machines) further assistance. Drive Motor NOTE... - Page 24 If the control panel displays a Drive Motor Error if off then back on. If the error persists, contact (E7), the control does not sense current coming your Authorized Stoelting Distributor for further from the drive motor. Press the On/Off button assistance.
-
Page 25: Troubleshooting - Machine
3 Replace o-rings. Front door leaks. 4 O-rings or spigot installed wrong. 4 Remove spigot and check o-ring. 5 Inner spigot hole in front door nicked 5 Replace front door. or scratched. Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 26: Troubleshooting - Autofi Ll Pump
3 Remove the air from the BIB syrup container. 4 Pump is clogged with debris or 4 Remove syrup valves and inspect for debris particulates. or improper closing that would interfere with operation. Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 27: Replacement Parts
208401 Brush - 1” X 3” X 10” 236054 Cleaning Card - Auto Fill Pump Kit 236065 Card - Cleaning Instruction - E122 & F122 236066 Card - Cleaning Instruction - Brix Pump 324105 Decal - Caution Electrical Shock 324106... -
Page 28: Auger Shaft And Faceplate Parts
5.2 AUGER SHAFT AND FACEPLATE PARTS Owner’s Manual #513667 E122 & F122 Model Machines... - Page 29 5.2 AUGER SHAFT AND FACEPLATE PARTS - CONTINUED Owner’s Manual #513667 E122 & F122 Model Machines...
-
Page 30: Hopper Parts
2187058 Mix Inlet Regulator E122 - 2 2187918 Mix Inlet Assembly (Auto Fill) 2187919 Clip - Retaining (Mix Inlet) 2203078 Cover - Hopper (Autofi ll) 2203206 Mix Inlet Regulator F122 - 2 Owner’s Manual #513667 E122 & F122 Model Machines... -
Page 31: Auto Fill Parts
Pump - Brix (3:1 Ratio) 616116 Water Regulator 647660 Screw - 10-32 x 3/8” 739126 Tie Wrap - 15” 739127 Tie Wrap - 7” 756221 Tubing - 3/8” Clear 6’ 756222 Tubing - 3/8” Braided 80’ Owner’s Manual #513667 E122 & F122 Model Machines... - Page 32 Owner’s Manual #513667 E122 & F122 Model Machines...
-
Page 33: Special Applications
SECTION 6 SPECIAL APPLICATIONS Owner’s Manual #513667 E122 & F122 Model Machines... - Page 34 Owner’s Manual #513667 E122 & F122 Model Machines...
- Page 35 Re: Application of Stoelting F122 and Arctic Quake Non-Dairy concentrate product Welcome to Arctic Quake Stoelting’s policy regarding cleaning of the equipment is that for the frequency of cleaning the freezer and freezer parts the end-user should refer to their state and local health regulations.
- Page 36 Owner’s Manual #513667 E122 & F122 Model Machines...
-
Page 37: Warranty
SECTION 7 WARRANTY Owner’s Manual #513667 E122 & F122 Model Machines... - Page 38 Owner’s Manual #513667 E122 & F122 Model Machines...
- Page 39 Stoelting’s sole obligations, and Buyer’s sole remedies, for any breach of this warranty shall be, at Stoelting’s option, one of the following: repair or replacement of the affected component at Stoelting’s plant in Kiel, Wisconsin, or refund of the purchase price of the affected Equipment. Stoelting, through an Authorized Stoelting Provider, will deinstall/reinstall the affected component from/into the equipment (“Labor”) for the period listed below in the Warranty...
- Page 40 Costs not covered by the Stoelting Travel Pay policy. Stoelting covers only the first trip travel which is a flat rate by mileage one- way from the service company’s home location to the job site. The flat rate is calculated as follows:...