Cleaning The Freezer Parts; Sanitize Freezer And Freezer Parts; Assembly Of Freezer; Cleaning Freezer Barrel - Stoelting 4231G Owner's Manual

J. Remove drain trays.
3.9

CLEANING THE FREEZER PARTS

Place all loose parts in a pan or container and take to the
wash sink for cleaning. To clean freezer parts refer to
the following steps:
A. Place all parts in warm mild detergent water and
clean with brushes provided. Rinse all parts with
clean hot water.
CAUTION
DO NOT DAMAGE PARTS BY DROPPING OR
ROUGH HANDLING.
B. Wash the hopper and freezer barrel with warm
detergent water and brush provided (Fig. 26).
Figure 26. Cleaning Freezer Barrel
C. Clean the drip tray and insert with a soap solution.
Rinse with clean hot water.
3.10 SANITIZE FREEZER AND
FREEZER PARTS
A. Use a sanitizer mixed according to manufacturer's
instructions to provide a 100 parts per million
strength solution. Mix sanitizer in quantities of no
less then two gallons (7.5 liters) of 120°F water. Allow
the sanitizer to contact the surface for 5 minutes.
Any sanitizer must be used only in accordance with
the manufacturer's instructions.
B. Place all parts in the sanitizing solution, then remove
and let air dry.
C. Using this sanitizing solution and the large barrel
brush provided, sanitize the rear of the barrel and
drive area by dipping the brush in the sanitizing
solution and brushing the rear of the barrel.
3.11

ASSEMBLY OF FREEZER

To assemble the freezer parts, refer to the following
steps:
Petro-Gel sanitary lubricant or equivalent must
be used when lubrication of parts is specified.
The United States Department of Agriculture and
the Food and Drug Administration require that
lubricants used on food processing equipment
be certified for this use. Use lubricants only in
accordance with the manufacturer's instructions.
A. Assemble all "O" Rings onto parts dry, without
lubrication. Then apply a thin film of sanitary
lubrication to exposed surfaces of the "O" Rings.
Apply thin film of sanitary lubricant to metal part of
rear seal. Also apply a thin film of sanitary lubricant
inside the hole on the front of the auger.
B. Assemble the rear seals onto the augers with the
large end to the rear. Be sure the "O" Ring is in place
before installing the rear seal.
C. Lubricate the inside of the auger drive sockets (rear)
with a small amount of white socket lubricant. A small
container of socket lubricant is shipped with the
freezer.
D. Screw the springs onto the studs in plastic flights.
Springs must be screwed into the flights
completely to provide proper tension (Fig. 27).
14
NOTE
NOTE