Disassembly / Reassembly Procedures
Disassembly Procedure
Disassemble the Power Sensor by performing the following steps:
Disassembly must be performed in sequence described in the following
CAUTION
procedure, otherwise damage may be caused to the two gold wires between
the bulkhead assembly and the Power Sensor Board Assembly. If these wires
are damaged, the A1 Bulkhead Assembly must be replaced.
Every power sensor has an individually prepared label on the housing. If more
NOTE
than one power sensor is disassembled at a time, be sure to mate the correct
power sensor and housing when reassembling.
1 Insert the blade of a large screwdriver between the two-piece plastic shell at
Keysight 8480 Series Operating and Service Manual
the rear of the Power Sensor. Gently pry the sections apart. (See .)
Service
3
69