Disassembly Procedure; Reassembly Procedure - Keysight Technologies E4412A Operating And Service Manual

1 Operation and Service Guide

Disassembly procedure

Figure 1-8
Disassemble the power sensor only in a static free workstation. Electrostatic
CAUTION
discharge will render the power sensor inoperative.
Disassemble the power sensor by performing the following steps:
1 At the rear of the power sensor, insert the blade of a screwdriver between the
2 Pry alternately at both sides of the connector J1 until the plastic shells are

Reassembly procedure

1 Replace the magnetic shields and the plastic shells as shown in
40
Removing power sensor shell
plastic shells (Figure
screwdriver blade as wide as the slot between the two shells.
apart. Remove the shells and the magnetic shields.
Snap the plastic shells together.
Keysight E4412A and E4413A Operating and Service Guide
1-8). To prevent damage to the plastic shells use a
Figure 1-8.