Disassembly And Reassembly Procedure; Table 4-11 Disassembly Procedure - Keysight Technologies U2000 Series Operating And Service Manual

Disassembly and Reassembly Procedure

Disassembly Procedure
Disassemble the power sensor by performing the following steps:
Disassemble the power sensor only in a static free workstation. Electrostatic discharge renders the
C A U T I O N
power sensor inoperative.

Table 4-11 Disassembly Procedure

U2000 Series Operating and Service Guide
1 Remove the top label.
2 Loosen three screws by using
M2 to remove the housing.
3 Replace the defective sensor
module with a new sensor
module. Please refer to
Table 4- 10.
Service 4
77