Reassembly Procedure - Keysight Technologies E Series Operating And Service Manual

4 Service
Figure 4-3
1 At the rear of the power sensor, insert the blade of a screwdriver between the
2 Pry alternately at both sides of the connector J1 until the plastic shells are

Reassembly procedure

Replace the magnetic shields and the plastic shells as shown in
the plastic shells together.
Repair and Adjustments
Do not attempt to repair or adjust the power sensor. Due to the extreme static
sensitivity of the power sensor, customer repair is not recommended. If your
power sensor should fail or need calibration, return it to Keysight Technologies.
Do not disassemble the power sensor. The power sensor is extremely static
CAUTION
sensitive and can be easily damaged. If the power sensor shows evidence of
attempted customer repair, the warranty may be voided.
Adjustments are usually required on a yearly basis. They are normally performed
only after a performance verification has indicated that some parameters are out
of specification. Performance verification must be completed after any repairs that
may have altered the characteristics of the E-Series E9300 power sensors. The
E-Series E9300 power sensors can be returned to Keysight for adjustments. To
arrange the return, contact the Keysight Service Center.
56
Removing power sensor shell
plastic shells (See Figure
screwdriver blade as wide as the slot between the two shells.
apart. Remove the shells and the magnetic shields.
4-3). To prevent damage to the plastic shells use a
Keysight E-Series E9300 Operating and Service Guide
Figure 4-2. Snap