Control Weighing And Target Weighing; Target Weighing - KERN ABP Set Up And Operating Manual

14.9 Control weighing and target weighing

This function is used to determine the matching of a weighing value to the specified
control values.
Control values can be exact target values (target weighing) or the limits set for the
tolerance range (control weighing) within which the weighing value is to be kept.

14.9.1 Target weighing

This mode e.g. is used for weighing constant liquid quantities or for assessment of
missing quantities or excess quantities.
The target value is the numeric value which corresponds to the nominal quantity of
the used unit. Beside the target value a tolerance value is entered. This is a
numerical value which is plus/minus over or under the acceptable target value.
Reaching of target value is shown on the diagram. The tolerance marks
or indicate whether the weighed good is below, within or above the
,
specified tolerances.
+
Settings
1. Calling Weigh Settings
In weighing mode press MENU button.
Press the R-Taste key and use the navigation
keys ,  to select < Weighing
Settings> and confirm using the OK-key.
2. Activate function
Use the navigation keys ,  to select
<Target measurement> and confirm using
the OK-key.
Select Settings <on> and confirm using

the OK-key.
3. Setting target value
 Select <Setting > and confirm using
the OK-key.
98 ABP-BA-e-1810