9.1.2 Overview of the display screen
Indicator for:
- Temperature selection
- Process temperature
- Entry of correction factor
Indicator for :
-
Drying mode selection
("modE")
-
Correction factor selection
("subCoF")
9.2 Operation
9.2.1 Weighing
Use the main switch (above the power plug) to switch on the balance. A short warm-
up period of approx. 10 minutes is advisable for stabilisation purposes.
Press the
key and wait for the "0" indication. Now it is ready for use.
Important: If the display does not show "0" press the
Only now (!) place object on the weighing pan. Make sure that the weighing object
does not stripe or touch the housing or base. Now the weight will be indicated.
If the object should be heavier than the weighing range allowance, "FULL" (over-
load) will appear on the display.
MLB50-3-BA-defsi-0310
Indicator for:
-
Set time
-
Test time
Main display panel:
- Function display
- Error messages
- Play back result
- Adjusting functions etc.
key.
47