Table of Contents
Advertisement
14.1 Parts counting
With parts counting you can either count parts into a container or remove parts from
a container. To count a greater number of parts the average weight per part has to
be determined with a small quantity (reference quantity). The larger the reference
quantity, the higher the counting exactness. High reference must be selected for
small parts or parts with considerably different sizes.
14.1.1 Settings
+
Enable function and calculate single weight by weighing a known
reference quantity
Selecting an application (see chap. 11.1.4)
The available applications will be displayed.
Use the navigation keys , to select
<Piece counting measurement>. The framing
will indicate the current selection. Confirm
using the OK-key and the application specific
settings will be displayed.
1. Storage location no. / name for initial
input
Use the navigation keys , to select
storage location and confirm using the OK-
key.
During the initial entry there will be a display
where you can enter a storage name.
Use the navigation keys , to select
storage location and confirm using the OK-
key.
If required, change name and confirm using
the OK-key.
To overwrite a stored single weight continue by referring to chap. 14.1.4
ABP-BA-e-1810
69
Advertisement
Table of Contents
