Amana ATX 518 VW Service Manual page 68

Kit Instructions
15. Install hinge (right) side trim on refrigerator door. Be
sure holes in trim align with holes in door.
Remove paper backing from adhesive on hinge (right)
side trim and press into place over the edges of trim
on top and bottom of door.
16. Rehang refrigerator door.
A. Check center hinge-bracket to be sure plastic
spacer is in correct position.
B. Place door on bottom hinge.
C. Close refrigerator door.
RS5280001 Rev. 0
D. Re-attach center hinge-pin on top side of door
using hex-head nutdriver.
IMPORTANT: If a 6.35 mm trim kit is to be installed,
turn NOW to STEP 3 in the 6.35 mm Trim Kit
Instructions to finish installation.
Proceed with Step 17 (below) only if the 3.175 mm trim
kit is to be installed alone.
17. Install decorator panel on front of refrigerator door.
A. To prevent scratching refrigerator door when
sliding panel into trim slots, cover outside edges
of rear panel surface with masking and put six
(6) evenly-spaced strips of masking tape across
the rear side of decorator panel.
B. Slide decorator panel into place.
18. Install handle (left) side trim on refrigerator door.
A. Before removing paper backing from alternat-
ing adhesive tape, check the fit by aligning tirm
snugly on side of door.
68