Kit Instructions
B.
Press handle (left) side trim into place over the
edges of trim on top and bottom of door.
6.
Re-attach refrigerator door handle.
A.
Secure screws on side and top of handle.
B.
Re-install screw cap cover by snapping into place.
RS5280001 Rev. 0
IMPORTANT: Permanent-type, double-sided adhesive
tape is attached to all trim pieces for easy
installation. Before peeling away paper backing
from tape, check the fit of the trim pieces and be
sure you understand how to install each one.
Damage to trim pieces could result if adjustment
or removal is attempted after installation.
7.
Remove handle (left) side freezer trim carefully, using
a taped putty knife.
8.
Install the handle (left) side 6.35 mm trim on pre-cut
freezer panel.
A.
Be sure front surface of trim piece faces decora-
tor surface of pre-cut panel. Hold trim piece at an
angle along side of panel while aligning end of trim
flush with one edge of panel.
B.
Press and turn front surface of trim around edge
of panel until trim piece fits snugly on edge of
panel.
60