Amana ATX 518 VW Service Manual page 58

Kit Instructions
510 liter and 538 liter Units
Freezer Door Panel
Refrigerator Door Panel 28-7/8" x 39-27/32"
594 liter and 623 liter Units
Freezer Door Panel
Refrigerator Door Panel 31-7/8" x 41-11/32"
Recommended Tools
To install the 3.175 mm trim kit and panels, use the
following basic tools.
• Phillips screwdriver
• taped putty knife
• small flat-blade screwdriver
• strapping (safety) tape
• tightly-fitting gloves and arm protection
To avoid possible injury, protect hands and arms. Trim
pieces may have sharp edges.
Installation Procedure
NOTE: The 6.35 mm trim kit fits only a refrigerator/
freezer in which a 3.175 mm trim kit has been
installed. Install a 3.175 mm trim kit before
proceeding.
1. Remove refrigerator and freezer door handles.
A. Using a taped small flat-blade screwdriver, lift
rear of screw caps on both doors.
RS5280001 Rev. 0
18-23/32" x 28-7/8"
47.54 cm x 73.34 cm
73.34 cm x 101.20 cm
19-7/32" x 31-7/8"
48.81 cm x 80.96 cm
80.96 cm x 105.01 cm
B. On both doors, remove screws from top and
bottom of each handle.
IMPORTANT: Permanent-type, double-sided adhesive
tape is attached to all trim pieces for easy
installation. Before peeling away paper backing
from tape, check the fit of the trim pieces and be
sure you understand how to install each one.
Damage to trim pieces could result if adjustment
or removal is attempted after installation.
2. Remove handle (left) side refrigerator trim carefully,
using a taped putty knife.
58